"MA Şap" 100 self levelling mortar (up to 1 cm thickness)

"MA Şap" 100 self levelling mortar (up to 1 cm thickness)

Product consumption calculator


Terms of use


Product description

Cement-based monocomponent flooring mixture, rich in chemical mixtures, providing formation of imporous surface. It is levelled in a self-levelling manner. The product conforms to the requirements of the AZS 039-2000 (TS 11140-1993) standard.

Fields of Application

This product can be applied in the following areas:

  • Formation of flat surface prior to the application of different materials, such as wood, laminate, parquet, carpet, PVC, ceramics;
  • Formation of strong surface resistant to erosion and dust in storages and similar facilities;


  • Easily prepared and used;
  • Creates flat, imporous surface,  in a self-levelling manner.

Preparation of surface. Please pay attention to the surface to be checked and be strong and removed of residues preventing adhesion. In case the surface has cracks or pores, they should be filled with Filkret repair mortar. The surface should be primed with Binmader primer to reduce the ability of water absorption of the surface and  increase its resistance.

Preparation of mixture.Gently pour out 20 kg dry mixture onto 4,0 liter water, and mix until balls and air bubbles disappear (to prepare the mixture it is recommended to use poor circulation mixer).

Application. Pour the prepared liquid mixture onto the surface. To remove air bubbles from the mixture during the application, and facilitate the levelling procedure, use prickly roller. If required, a steel trowel can be used to accelerate levelling. The surface applied with the product should be protected from wind and direct sun for 24-hour period.

Recommendations. In case the MA Şap product ambient temperature is within +50C and +300C, a required temperature should be provided. The product should not be used in hot (more than +300C), rainy and windy weather conditions. After use all appliances and tools should be cleaned with water.

Technical specifications



Operating temperature

+50 C - +300 C

Water /dry mixture ratio

4,0 liter of water /20 kg  powder mix

Useful life

35 minutes

Application thickness

3,0 – 10,0 mm

Hardening period:

  • initial
  • final


In 15-30 minutes

In 60-90 minutes

Compression strength limit:

  • in 7 days
  • in 28 days


23 MPa

35 MPa


1,2 MPa

Period of putting into operation

In 6 hours the surface can be open for movement. After 24 hours carpet, parquet, ceramics, etc. can be applied onto the surface.


20 kg sacks made of 2 or 3-layer kraft paper and 1 layer of polyethilene


The product consumption for 1 msurface area with 1 mm thickness is 1.75 kg.

Shelf Life and storage

The product can be stored during 12 months in dry conditions, with maximum 10 sacks laid one on another.


  • Taking into consideration that the MA Şap product is a cement-based, complex mixture, immediately rinse it with water in case of contact with skin or eyes;
  • Do not add any substances not indicated in the  application procedures;
  • Specifications indicated above were received on the basis of laboratory tests conducted in the ambient conditions of +230C±20C temperature and 50% +5% humidity. Depending on the ambient conditions these specifications may be changed.

Warranty and technical support

  • information indicated in technical specifications is based on scientific and experimental data;
  • Matanat А company is responsible for the product quality only;
  • with the exception of cases of works executed under the supervision of the company specialists, Мatanat А company shall not be liable for any problems occuring due to improper use of the product by other persons;
  • the company reserves the right to make changes in its product in consequence of scientific-and-technical development;
  • for technical support and/or more information please do not hesitate to contact the Matanat А company!