"İNQİLAB" cement-based ready plaster

"İNQİLAB" cement-based ready plaster

Product consumption calculator



Product description

Cement-based plaster with a light filler that is highly hydraulicly polymerized, rich in admixtures increasing the useability of the product, monocomponent, that is resistant to frost, water and external impacts, that has a high resistance and elasticity, and that does not crackle after getting dry. The product conforms to the requirements of the ГОСТ 28013-98 standard.

Fields of Application

This plastering product can be applied in the following areas:

  • Plastering of concrete surfaces, walls and ceilings built from lightweight concrete;
  • Bricklaying, as well as laying of other types of stones;
  • plastering of walls and ceilings built from precast concrete and gas concrete.


  • prevents formation of cracks on treated surfaces;
  • the surface plastered with a plastering mixture does not permeate water or moisture to the reverse side;
  • allows facing and finishing works on walls onto which the mixture is applied either directly or using a spackling paste  (primer plaster is saved);

Application procedures

Preparation of surface. Residues preventing adhesion shoud be cleaned off the surface prior to plastering, and the surface should be strong. In case the surface has cracks or broken parts, they should be filled with Filkret repair mortar. Before treatment the surface should be dampened or primed with Binmader primer to achieve  a better result.

Preparation of mixture. Pour out 25 kg dry mixture in portions of 5,0 – 6,0 liter of water and mix until it is entirely homogeneous (to prepare the mixture it is recommended to use poor circulation mixer). Wait for 3-5 minutes to allow totally mixing of substances composing the mixture, mix again before application.

Application. Gently apply the 5 to 10 mm thick mixture to the surface with a trowel. Use the prepared mixture during 120 minutes. Do not use expired mixture. It is recommended to dampen the surface during 24 hours after use.

Recommendations. In case the temperature of the environment where INQILAB machine plaster mixture is used is less than +50C or more than +300C, required temperature should be provided. The product should not be used in hot (more than +300C), rainy and windy weather conditions. No water or dry mixture should be added to the expired mixture. After use all equipment and tools should be cleaned with water.


The INQILAB plaster mixture consumption for plastering of 1 m2 surface area with 8-10mm thickness is 13-14 kg. 25 kg of the INQILAB plaster mixture is enough to plaster the surface with the area of approximately 2 m2.

Shelf Life and Storage

The product can be stored during 12 months packed in unopened sacks in dry conditions, maximum 10 sacks laid one on another.


  • taking into consideration that the ИНГIЛАБ plaster mixture is rich in mixtures, immediately rinse it with water in case of contact with skin or eyes;
  • do not add any substances not indicated in the application procedures;
  • store the product in dry conditions, maximum 10 sacks laid one on another
  • Specifications indicated above were received on the basia of laboratory tests conducted in the ambient conditions of +230C±20C temperature and 50% + 5% humidity. Depending on the ambient conditions these specifications may be changed.

Warranty and technical support

  • information indicated in technical specifications is based on scientific and experimental data;
  • Matanat А company is responsible for the product quality only;
  • with the exception of cases of works executed under the supervision of the company specialists, Мatanat  А company shall not be liable for any problems occuring due to improper use of the product by other persons;
  • the company reserves the right to make changes in its product in consequence of scientific-and-technical development;
  • for technical support and/or more information please do not hesitate to contact the Matanat А company!